Retro-fitting your Old Engine
|
| To retro-fit your old engine, for example
Dimension Edge (this example is of the 43cc
Mitsubishi 2-stroke on Golden Eagle 76mm
clutch mount set-up). If you don't have the
proper tools, take the engine to a small
engine shop, all the lock-tight used by Edge
makes the engine VERY hard to take apart
- something you've probably already learned.
If you don't know the clutch size of your
engine take the engine to a Small Engine
Repair Shop, to find out. We don't Know All
small engines nor have the manpower to research
all engines - this kit IS for the "Do-It-Yourself"ers. |
**Click Here to Order the Mount Kit Only**
|
|
|
|
1) Remove the fly-wheel cover cover.
|
|
2) Remove the drive shaft assembly. (two
bolts)
Your engine is now
ready for installation
of clutch shoes.
|
|
|
|
|
3) Install the clutch shoes, Tighten bolts.
Our mount kit with 76mm clutch does Not include
clutch shoes. Clutch
shoes can be purchased
at the small engine
shop.
|
|
4) Install the Clutch Housing and tab for
Safety Cover - safety
cover tab goes on upper
left bolt of clutch
housing. Tighten bolts.
|
|
|
|
|
5) Remove the Edge throttle/gear shift cable.
Install the GEBE
spring loaded trigger throttle
assembly.
|
|
6) Finally, bolt on the GEBE engine bracket.
You have completed
installation of your
engine
onto the GEBE engine
Mount Kit w/o Engine
and are now ready
to Install the Engine
on
your bicycle.
Printed instructions
included with kits.
|
|
|
|
